Saturday, March 14, 2009

more fitting glue-up

OK, Milled glass fibers came in the mail and so now onto mixing into a thick slurry with epoxy to finish off the T-nuts that mount the petcocks, and then the gas cap assembly.

I pressed some PVA-released positioning plates into the mixture as it'll make a flat surface interface to the petcocks.

I took the outer surface of the tank down to 600grit sandpaper to clean up the flash and a few boogers on the outer surface; It'll look okay once I get a coat of wax on there, kind of satin hopefully.

No comments :

Post a Comment